Компьютерные сети. Обжимка кабелей, настройка подключений и общий

Network And Internet Connectivity


Make sure the router is on and the device is in the zone of operation.

If the device is too far from the router, it won't catch the signal, so make sure the device is in the area of operation.

Make sure the Wi-Fi interface is on and the network's out.

Choose the “Constallations” stat Wi-Fi and make sure the Wi-Fi interface is on. Press the name of the Wi-Fi network that needs to be connected. The blue tie next to the name of the network means the device is connected to it. Find out what to do if you can't turn on Wi-Fi.

If there's a request, get the Wi-Fi password.

Even after the introduction of the right password, it is possible to conclude " unable to connect to the network " or " wrong password " , then repeat the attempt to impose the password.

width="350"Wi-Fi network problem check

If iOS detects a problem with the Wi-Fi connection, you can see recommendations to remove it under the name of the Wi-Fi network, which is connected. For example, notice " No Internet connection " may be displayed. For further information, press the name of the Wi-Fi network.

Checking cables and connections

If access to the network or the Internet is still unsuccessful, make sure that the router is connected to the modem and on.


Try rebooting iOS, router, cable or DSL-mode. To reboot the router or modem, disconnect it from the electrical dispenser, then reconnect it.

After reset of each device, check if the malfunction is removed.

Still unable to connect?

Remove the network ' s designs by selecting the " Construction " of the " Basic " , " Off-road " . Wi-Fi and password networks, cell network construction and VPN and APN parameters previously used are also dropped.